What the call usually is
Pump problems in the Lynnwood area announce themselves — a hum with no flow, a grind on high speed, a damp pad under the motor, or a FLO code that will not clear. We diagnose with the pump running, not from the symptom alone.
A spa pump has two halves: the wet end that moves water and the motor that drives it. In the Lynnwood area we repair the wet end when the motor is sound, replace the pair when the bearings have gone, and say which one it is before we quote.
Cabinets stay damp from October to April. A damp equipment bay is hard on motor bearings and capacitors, and most of the the Lynnwood area pumps we replace show rust on the shaft before the seal fails.
The tubs on our route range from thirty-year-old Hot Springs to last year's Bullfrog. Pumps on those units are in their second or third life, and the question for a the Lynnwood area owner is usually whether to reseal the wet end or fit a new pump; we lay out both prices.
What owners describe on the phone
Hums but no water moves
A seized impeller or a failed start capacitor. The motor is often fine; we free the shaft or fit a capacitor and the pump runs.
FLO, LF or no-flow code
The pack is not seeing enough water past the pressure or flow switch. Filter, air lock, worn impeller or a lazy circ pump — in that order.
Water under the pump
Shaft seal weeping onto the pad. Fix it before the water reaches the motor bearings and turns a seal job into a pump job.
Grinding or screaming on high speed
Bearings going, usually after a seal leak. There are weeks of warning before the motor locks; use them.
How the visit runs
- A call half an hour before we arrive
- Diagnosis with a meter, then one written price you approve
- Water hardness and alkalinity checked and noted
- Special-order parts arrive the next business day in most cases
- If the tub is not worth fixing, we say so
Scope, plainly: the spa and what lives inside its skirt. New circuits, supply plumbing and setting new tubs go to an electrician or a dealer.