(425) 464-7076
South Sound Hot Tube Repair — all ten towns

Hot Tub Leak Repair

Leak location and repair in the equipment bay and the plumbing: pump seals, unions, heater gaskets, jet bodies, manifolds and glued joints.

Same-day most daysAll brandsOne written priceLynnwood to Everett, Shoreline to Kenmore
Home›Services›Leak Repair

What the call usually is

A leaking hot tub in the Lynnwood area is rarely the shell. It is a pump seal, a union, a heater gasket, a jet body or a glued joint somewhere in the foam — and finding it is most of the job. We start at the equipment bay and work outward.

Water loss in the Lynnwood area has two innocent explanations — evaporation and splash-out — and a long list of real ones. The tape test separates them: mark the level, cover on, 24 hours. If it dropped more than a quarter inch, call us.

Cabinets stay damp from October to April. A persistently wet cabinet in the Lynnwood area hides slow leaks for months; we pull the panels on all four sides and dry the bay before we trust what we see.

Our route covers mid-century grids, 1980s subdivisions and new townhomes. Tubs on older slabs and decks around the Lynnwood area settle, and a tub that is out of level stresses unions and jet bodies on the low side — we check level before we check joints.

Henry at an open hot tub equipment bay on a leak repair call near Lynnwood, WA
Leak Repair: the cabinet comes open and the meter goes on before anything is quoted.

What owners describe on the phone

Level drops an inch or more a week

Beyond evaporation. We tape the level, confirm the loss, then isolate: pump off versus pump on tells us whether it is pressure side or suction side.

Wet pad under the equipment door

Nearly always a pump shaft seal, a union o-ring or the heater manifold gasket. All three are same-day repairs with parts off the van.

Damp foam, no obvious source

A jet body or a glued joint inside the foam. We find it with the moisture meter and dye, cut only what is needed, and re-foam.

Leak only when jets run

Pressure-side plumbing — a jet gasket, a diverter or a cracked manifold. The tub holds water when idle and loses it under pressure.

How the visit runs

Scope, plainly: the spa and what lives inside its skirt. New circuits, supply plumbing and setting new tubs go to an electrician or a dealer.

Leak Repair by town

Questions about leak repair

Is my the Lynnwood area tub leaking or just evaporating?
Mark the level with tape, cover on, 24 hours. Up to a quarter inch in a day is evaporation in our climate; more than that, and a wet spot anywhere, is a leak. Call with the number and we bring the right kit.
Do you cut into the foam?
Only where the moisture meter says the water is. Most the Lynnwood area leaks are in the equipment bay and need no foam work at all.
Can a shell crack be repaired?
Acrylic cracks can be repaired, but they are rare — under one in twenty leak calls in the Lynnwood area. We rule out everything else first.

Leak Repair anywhere on the route?

Call with the symptom; we bring the likely parts.